![]() power supply) in parallel with DTC1000/2000 during the installation. DO NOT touch the internal terminals no matter the power is on or off. DO NOT touch any internal circuit within this period. Wait at least one minute after the power is off to allow the capacitor to discharge. DO NOT touch the terminals or repair the controller when the power is on to prevent electric shock. Make sure the power cable and signals device are installed correctly before switching on the power of DTC1000/2000 otherwise serious damage may occur. Shorten the wire when wiring a platinum resistance thermometer (RTD) to the controller, and separate power cable from load wires to prevent interference and conductive influence. Be sure to use compensating wires that match the thermocouple types when extending or connecting the thermocouple wires. Do not install and/or use the controller in places subject to: dust or corrosive gases and liquid high humidity and high radiation vibration and shock Switch off the power when wiring or changing input sensors. DO NOT modify or disassemble the controller. WARNING! Prevent dust or metallic debris from falling into the controller that will cause malfunction. key or specific tools are required to open the enclosure) in case danger and damage on the device may occur. ![]() The enclosure should prevent non-maintenance staff from operating the device (e.g. Please read this instruction sheet before using your DTC1000/2000 series to ensure proper operation, and please keep this instruction sheet handy for quick reference.ĭANGER! Caution! Electric Shock! DTC1000/2000 series is an OPEN-TYPE device and therefore should be installed in an enclosure free of airborne dust, humidity, electric shock and vibration. Thank you very much for purchasing DELTA DTC1000/2000 Series Temperature Controller. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |